Mr. Bulletfeeder - 308 Winchester

Please note:

The Dillon XL750 Powder Measure is angled such that the powder bar must extend directly over station #4 in the toolhead, and it cannot be repositioned. This Is not an issue if you have a short die in that station. However, if you wish to run a powder check in station #3, and a bullet dropper in station #4, as many do, this creates a serious problem.

As a solution to this issue, the designers at Double Alpha Academy came up with Extra-Short Dillon Powder Bar. The DAA Extra-Short Dillon Powder Bar is available in two variants (small & large), and needs to be bought separately.

• DAA Extra-Short Dillon Powder Bar - Small
• DAA Extra-Short Dillon Powder Bar - Large

This device allows you to see your press in a whole new light. A patented bullet feeder is specially designed for the Dillon Precision XL650 and 1050 presses. Mr. Bulletfeeder will change the swift operation of these progressive beasts to unmatched sprint.

Mr.Bulletfeeder is also compatible with other presses; we are available for consultation - don't be afraid to ask!

After first use, you just fall in love with the bullet feeder.

Note: No expanding powder funnel is included with rifle bullet feeding system, because throating the rifle brass in the powder funnel is not possible. That would lead to too small a powder through hole. Flaring the brass must be done as a prep stage or using expanding Lyman M-die on the Dillon 1050.

• Patented construction
• Attached on casefeeder
• Great price
• Power 220V
• Especially designed for ogival bullets
• Not designed for Alox coating