Discontinued Products

Percussion caps Sellier&Bellot velikost 4,7. Personal pickup only!!!

New, unprimed 444 Marlin brass case for ammo reloading. Made by Remington.

Spare part for LEE Bullet Feed Kit dia .30-9mm, up to 19mm bullet length.

Spare part for LEE Bullet Feed Kit dia .40-.50, up to 20mm bullet length.

Full Length Sizing Die Only .284 Winchester

The Professional Gun Vise Cleaning Maintenance System VersaCradle from Berry's.

The X-Block is the right tool for anyone driving pins out of firearms. It has all the features to get the job done smoothly and professionally.

Berry's C-Clamp for mounting the VersaCradle™ 360° Ball & Case system to the benchtop.

Case Trimmer pilot no. 47 for use with Lyman Cas Trimmer. Designed for .475 Wildey and .480 Ruger cases.

Lee Precision .300 Weatherby Mag Collet Necksizing Die for ammo reloading. Deprimes the case and sizes just the neck, so it requires no lubrication. Thread 7/8"-14.

A compact screwdriver set containing of the most commonly used bits. Wheeler Engineering.

Wheeler's FAT Wrench brings perfect consistency to every screw on your rifle!

With Wheeler® Ultra Scope Mounting Kit you can level your rifle and scope, mount your scope to the rifle, and bore sight your scope with precision and accuracy.

New, unprimed 7,92x33 Kurz brass case for ammo reloading. Made by PPU.

New, unprimed 8x68S brass case for ammo reloading. Made by RWS.

New, unprimed 8x56 R Hungarian brass case for ammo reloading. Made by PPU.

New, unprimed 32 Winchester Special brass case for ammo reloading. Made by Winchester.

New, unprimed 8,15X46 R brass case for ammo reloading. Made by RWS.

Full Length Sizing Die Only 44-40

New, unprimed 6,5x65 R brass case for ammo reloading. Made by RWS.

New, unprimed 6,5x70R brass case for ammo reloading. Made by HH.

LEE CHARGE DISK A

LEE CHARGE DISK B

Lead shot charge bar for single stage shotshell reloading presses MEC.

Primers RWS 5,5 LR Berdan 5620. Personal pickup only!!!

Over-powder pads Diana cal. 16ga, height 2mm.

Powder Bushing #38 for setting MEC powder measure.

Caldwell Cross Wind Professional Anemometer.

Modernized Lee safety primer feed return spring. Used in GEN1 primer feed.

Trusty companion to keep your knives sharp on-the-go. Two-sided „V“ sharpener with carbide (coarse) and ceramic (fine) side.