RCBS bullet puller collet .348 (8,8mm)

This collet is designed to be used with the RCBS® Standard Bullet puller to remove bullets caliber .17 (4mm)

C-H BP Collet - caliber .45

C-H BP Collet - caliber .44

C-H BP Collet - caliber .41

C-H BP Collet - caliber .40

C-H BP Collet - caliber .375

C-H BP Collet - caliber .357

C-H BP Collet - caliber .348

C-H BP Collet - caliber .338

C-H BP Collet - caliber .323

The 1-1/2-inch-12 Bullet Puller quickly removes bullets from loaded ammunition to salvage components with the AmmoMaster®-2 or AmmoMaster .50 BMG press.

This collet allows the quick removal of bullets from loaded ammunition to salvage components when used with the 1-1/2-inch—12 Bullet Puller.

This collet allows the quick removal of bullets from loaded ammunition to salvage components when used with the 1-1/2-inch—12 Bullet Puller.

The Lyman MAGNUM INERTIA BULLET PULLER will safely remove a projectile from a loaded round without damage to the case or bullet. Two exchangeable collets allow delaboration from 5.7 X 28 caliber to the largest Magnum.

This is high-quality replacement chuck assembly, designed to fit with your existing RCBS Pow'r Pull®. With three available case-holding chucks, this assembly can accommodate a wide range of different cases. Size: Small

This is high-quality replacement chuck assembly, designed to fit with your existing RCBS Pow'r Pull®. With three available case-holding chucks, this assembly can accommodate a wide range of different cases. Size: Standard

This is high-quality replacement chuck assembly, designed to fit with your existing RCBS Pow'r Pull®. With three available case-holding chucks, this assembly can accommodate a wide range of different cases. Size: Magnum

The RCBS Pow'r Pull II Bullet Puller is an essential tool for any reloader. Featuring a sturdy one-piece body, ergonomic handle, and 3 case-holding chucks that fit cartridges from 5.7x28mm and .22 Hornet to WSM and RUM families.