CED7000 GEN-1/2 Replacement Battery

Replacement Battery for CED7000 GEN-1 and GEN-2 Shot Timers

The 1200 mAhrechargeable replacement battery is designed for CED7000 GEN-1 and GEN-2 shot timers. It is the newer, higher-capacity version used in CED7000 GEN-2 timers. The original GEN-1 models were equipped with a 900 mAh battery.
After extended use, typically around two years, the performance and capacity of the rechargeable battery may gradually decrease. In this case, the original battery can be replaced with a new one to extend the operating time of the timer.

Follow these instructions when replacing the battery:

The battery can be replaced by the user. However, care must be taken when disassembling the timer, as there are small connectors and other components inside that can easily be damaged if handled incorrectly.

Remove the small screws from the back of the timer and carefully separate the two halves of the housing. Pull the two halves evenly and straight apart, not at an angle, to avoid damaging the internal connectors.

In the oldest CED7000 GEN-1 timers from the first and second production runs (approximately June–July 2006), the two halves are connected by wires. In this case, do not pull the halves too far apart to avoid damaging or pulling the wires loose.

Disconnect the original battery and connect the new one. We recommend securing the battery inside the timer with double-sided adhesive tape or hot-melt glue to prevent it from moving during use.

When reassembling the timer, make sure the connectors and the plastic part between the Start and Review buttons are correctly aligned. Press the two halves of the housing together until they click securely into place, then reinstall the screws.

Do not overtighten the screws!

Dispose of the used battery in accordance with applicable regulations.